- Single-Point Lubricators
- Multi-Point Lubricators
- Industrial Fittings
The MEMOLUBÂ® EPS lubricator automatically delivers a small, precise amount of lubricant at regular intervals for an continuous supply of fresh lubricant directly to your lube point. Prevents over and under lubrication problems related to manual lubrication.
All MEMOLUBÂ® EPS models use the same motor base assembly, making it easy to convert from one lubricant capacity to another by simply purchasing a low cost transparent housing kit.
Connecting Power to the EPS
The MEMOLUBÂ® EPS is supplied with a 12" wire lead that is connected to an external power source. A constant 24VDC power is supplied during periods of machine operation and will continue to follow the program until power is removed. When initial power is supplied to the MEMOLUBÂ® EPS lubricator it will cycle once and then follow the preset MEMO program. When power is turned off the lubrication cycle stops until power is reestablished.
Programming the MEMO System for use with the MEMOLUBÂ® EPS
The MEMOLUBÂ® EPS lubricant output is programmed using the simple MEMO system. It consists of a brass MEMO fitting, a black plastic timing-ring holder, and three plastic timing rings (one white, one red, and one black). The MEMO can be programmed to control both the frequency of lube cycles and the volume of lubricant discharged. Once the MEMO is programmed and installed any MEMOLUBÂ® EPS lubricator will recognize the settings.
Basic Frequency Settings
There are 7 basic frequency settings that are suitable for most industrial applications. They are programmed by installing one or a combination of the three colored timing rings into the ring holder attached to the brass fitting. When you screw the MEMOLUBÂ® lubricator onto the brass fitting, the timing rings depress the switches on the bottom of the lubricator. This activates the lubricator program.
Adjusting the Volume of LubricantIncluded in the MEMO kit is eight spacer washers for adjusting the amount of lubricant discharged per lube cycle. Installing one, or a combination of all eight washers, into the brass MEMO fitting will limit the stroke length of the piston inside the lubricator.
Case Study No. Case Study 030119 - Conveyor
Steel, Aluminum, Glass & Plastic
This steel mill operating 24/7 was manually lubricating the conveyor bearings.
The daily manual lubrication procedure on the conveyor bearings were time consuming and often forgotten due to the inaccessibility and harsh environment.
The 350psi output pressure of the MEMOLUBÂ® HPS 480 allowed the lubricators to be mounted in a safe location outside the guarding with lube lines running to the bearings.
The MEMOLUBÂ® provided continuous supply of lubricant to each bearing which reduced production downtime, bearing failures man hours.
They used braided rubber hose to prevent damage to the lube lines in the harsh environment.
|Product Description||Item Number|
||See MEMOLUB Replacement Kits page|
|See Pre-filled Tubing Data Sheet|