- Single-Point Lubricators
- Multi-Point Lubricators
- Industrial Fittings
The MEMOLUBÂ® HPS lubricator automatically delivers a small, precise amount of lubricant at regular intervals for an continuous supply of fresh lubricant directly to your lube point. Prevents over and under lubrication problems related to manual lubrication.
All MEMOLUB HPS models use the same motor base assembly, making it easy to convert from one lubricant capacity to another by simply purchasing a low cost transparent housing kit.
Simple MEMO Programming
The MEMOLUBÂ® HPS daily lubricant output is programmed using the simple MEMO system. The MEMO can be programmed to control both the frequency of lube cycles and the volume of lubricant discharged. Once the MEMO is programmed and installed any MEMOLUBÂ® HPS lubricator will recognize the settings.
Basic Frequency Settings
There are 7 basic frequency settings that are suitable for most industrial applications. They are programmed by installing one or a combination of the three colored timing rings into the ring holder attached to the brass fitting. When you screw the MEMOLUBÂ® lubricator onto the brass fitting, the timing rings depress the switches on the bottom of the lubricator. This activates the lubricator program.
Adjusting the Volume of LubricantIncluded in the MEMO kit is eight spacer washers for adjusting the amount of lubricant discharged per lube cycle. Installing one, or a combination of all eight washers, into the brass MEMO fitting will limit the stroke length of the piston inside the lubricator.
Case Study No. 817 -- Coil Cutting Machine
General Production Equipment
Lubrication could only be performed when machine was stopped. This lead to irregular and infrequent lubrication.
Installed three MEMOLUBÂ® MEGA units with 5-Point and 8-Point distribution blocks set at 3 months. Now the machine gets regular lubrication without stopping production.
|Product Description||Item Number|
||See MEMOLUB Replacement Kits page|
|See Pre-filled Tubing Data Sheet|